Quality Control
Goldeagle technology has very strict standard for the quality of the parts, we will run the testing for each and every parts through our QC department for visual inspection testing before we will arrange the shipping for the parts to our customer.
For more function testing we can send the parts to the third party testing department for testing by customer's need, the testing fees for the third party testing department will be paid on the customer's side, if in any reason, the parts didn't pass the testing, we will over come the testing fees.
Basic service of the third testing department provides:
External Visual Inspection
X-Ray Inspection
Full AC/DC Electrical Testing
Internal Die Verification
X-Ray Inspection
X-beam examination is a non-ruinous test. It is a procedure to confirm the bond wire connections, die size comparison and ESD damaged. At testing centers our common example part check is 5 tests or 100%depending client prerequisite. Counterfeit parts can be decided by contrasting the structure of the die with a known good part. Part ought to be indistinguishable from bond wire area to die size. X-Ray perform base on AS5553 and MIL-STD-883 2012.7.
Internal Die Verification
This is a procedure used to uncover the interior structure of an integrated circuit. The decap procedure is finished using a blend of 98% fuming Nitric acid and 20% fuming Sulfuric acid heated to a specific temperature. This blend is the constrained into a small opening in a gasket to draw away polymer encapsulates or outside of a device using a Nicene Technologies Jet etch Pro decapitation machine. This creates a cavity in advice uncovering bonding wires, interior structure, and the die.
Full AC/DC Electrical Testing
A variety of electrical bench gear (DC power supplies, Digital Multi meters, LCR and Source Meters) can be coordinated to play out an arrangement of component level tests. Also, the utilization of both low and high power curve tracers can be utilized to assess input and output information of components. The pin to pin curve features can likewise be utilized to compare known "good" parts with obscure parts to give some minimal level of examination on the parts. Additionally, the pin to pin curve trace is useful amid failure analysis.
External Visual Inspection
Visual Inspection is a term utilized for reviewing electronic parts under a magnifying lens to determine whether a gadget has been changed from its unique state. Amid this procedure a device may hint at non-conformance or irregularities that assists to decide whether a device has been used or if a device is new and unique. This procedure is regularly performed by a Components Test Lab or Test House for short. This procedure is a parts-friendly and devices can be utilized subsequently. There are a numbers of things to search for amid a visual assessment.